22 Problem Solving
742
Problem Solving
22
Part of the image
is missing on the
copy.
The paper is damp. If the paper is damp, the copy image may be
partially missing or unclear. Replace the
paper with a new one.
Refer to "Loading Paper" (P.104).
Folded or wrinkled paper is
included in the tray.
Remove the unsuitable paper or replace all of
the paper with a new one.
Refer to "Loading Paper" (P.104).
The document is pasted or
folded.
The pasted or folded section may not be
laying flat on the document glass. Place a
stack of white sheets on top of the document
to flatten the document against the
document glass.
The copy has a
stripe pattern.
The document enlargement
ratio is too large.
Vertical stripes may be printed on the copies
depending on the ratio. Adjust the ratio to
eliminate the stripes.
Refer to "Reduce/Enlarge (Making Enlarged/Reduced
Copies)" (P.140).
The copy is
misaligned or
skewed.
The document is not loaded
correctly.
Load the document correctly.
Refer to "Copying Procedure" (P.126).
The document guides on the
document feeder are not set
in the correct positions.
Load the document correctly, and align the
document guides to the document.
Refer to "Copying Procedure" (P.126).
The paper tray is not inserted
correctly.
Firmly push in the tray until it stops to set it
properly.
Refer to "Loading Paper" (P.104).
The paper guides in Tray 5
are not set in the correct
positions.
Load the paper correctly, and align the paper
guides to the paper edges.
Refer to "Loading Paper in Tray 5 (Bypass)" (P.106).
Unable to copy
with the specified
size.
The document glass or the
document cover is dirty.
Clean the document glass or the document
cover.
Refer to "Cleaning the Document Cover and Document
Glass" (P.679).
The document is a
transparent type such as a
transparency film.
Place a white sheet of paper on top of the
document when copying.
The document is misaligned. Load the document correctly.
Refer to "Copying Procedure" (P.126).
The document guides on the
document feeder are not set
in the correct positions.
Load the document correctly, and align the
document guides to the document.
Refer to "Copying Procedure" (P.126).
The document is a non-
standard size.
Specify the document size, and then copy.
Refer to "Copying Procedure" (P.126).
The document is folded. Flatten the curl and load the document
again.
Refer to "Copying Procedure" (P.126)
Unable to copy in
color.
[Output Color] is set to [Black
& White].
Set [Output Color] to [Auto Detect] or [Color].
Refer to "Output Color (Selecting the Color for
Copying)" (P.148).
Symptom Cause Remedy
To Next Page
Loading...
