© 2011 Fujitsu Technology Solutions
112
9.2.6.3 Configuring Console Log
This allows the messages logging to any serial device attached to the host.
Figure : Console Log Config
Selection Criteria
Admin Status -A log that is "Disabled" shall not log messages. A log that is "Enabled" shall log
messages. Enable or Disable logging by selecting the corresponding line on the pull down entry
field.
Severity Filter - A log records messages equal to or above a configured severity threshold. Select
the severity option by selecting the corresponding line on the pull down entry field. These severity
levels have been enumerated below:
• Emergency (0): system is unusable
• Alert (1): action must be taken immediately
• Critical (2): critical conditions
• Error (3): error conditions
• Warning (4): warning conditions
• Notice(5): normal but significant conditions
• Informational(6): informational messages
• Debug(7): debug-level messages
Command Buttons
Apply - Update the switch with the values you entered.
To Next Page
Loading...
