© 2011 Fujitsu Technology Solutions
289
Address to the Radius servers. If not mentioned, then the outgoing interface IP address that is used
to send the packet to the Radius server is added as NAS-IP Address.
Radius Attribute 95 (NAS-IPv6 Address) - Select if the Radius Attribute 95 (NAS-IPv6 Address)
inclusion in Radius Requests is enabled or disabled. Mention explicitly the IPv6 address to be sent
as NAS-IPv6 Address to the Radius servers. If not mentioned, then the outgoing interface IPv6
address that is used to send the packet to the Radius server is added as NAS-IPv6 Address.
Non-Configurable Data
Current Server - The IP address or host name of the current server. This field is blank if no servers
are configured.
Number of Configured Servers - - The number of RADIUS servers that have been configured. This
value will be in the range of 0 and 3.
Command Buttons
Apply - Send the updated screen to the switch and cause the changes to take effect on the switch
but these changes will not be retained across a power cycle unless a save is performed.
Refresh - Update the information on the page.
To Next Page
Loading...
