Fujitsu PRIMERGY BX900 - Page 488

© 2011 Fujitsu Technology Solutions
486
10.4.11.7 switchport unicast {bps|pps} <1-4294967295> [k|m|g]
This command will protect your network from unicast storms by setting a threshold rate for unicast traffic
on each port.
Syntax
switchport unicast {bps|pps} <1-4294967295> [k|m|g]
no switchport unicast
bps: bit per second, specify the rising threshold bit rate for unicast storm.
pps: packet per second, specify the rising threshold packet rate for unicast storm.
<1-4294967295>: threshold rate range is from 1 to 4294967295.
[k|m|g]: rate unit, k means threshold rate would be multiply 1000, m means threshold rate would be
multiply 1000000, g means threshold rate would be multiply 1000000000.
no - This command set the threshold rate to default.
Default Setting
512 pps
Command Mode
Interface Config
This command will protect your network from unicast storms by setting a threshold rate for unicast traffic
on all ports.
Syntax
switchport unicast all {bps|pps} <1-4294967295> [k|m|g]
no switchport unicast all
bps: bit per second, specify the rising threshold bit rate for unicast storm.
pps: packet per second, specify the rising threshold packet rate for unicast storm.
<1-4294967295>: threshold rate range is from 1 to 4294967295.
[k|m|g]: rate unit, k means threshold rate would be multiply 1000, m means threshold rate would be
multiply 1000000, g means threshold rate would be multiply 1000000000.
all - This command represents all interfaces.
no - This command set the threshold rate to default.
Default Setting
512 pps
Command Mode
Global Config