Fujitsu PRIMERGY BX900 - Page 596

© 2011 Fujitsu Technology Solutions
594
10.6.18.3 show sflow receivers
Use this command to display configuration information related to the sFlow receivers.
Syntax
show sflow receivers [<index>]
<index> - Receiver index.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Receiver Index: The sFlow Receiver associated with the sampler/poller.
Owner String: The identity string for receiver, the entity making use of this sFlowRcvrTable entry.
Time Out: The time (in seconds) remaining before the receiver is released and stops sending samples
to sFlow receiver.
Max Datagram Size: The maximum number of bytes that can be sent in a single sFlow datagram.
Port: The destination Layer4 UDP port for sFlow datagrams.
IP Address: The sFlow receiver IP address.
Address Type: The sFlow receiver IP address type. For an IPv4 address, the value is 1 and for an
IPv6 address, the value is 2.
Datagram Version: The sFlow protocol version to be used while sending samples to sFlow receiver.