Fujitsu PRIMERGY BX900 - Page 790

© 2011 Fujitsu Technology Solutions
788
10.19.2.3 queue trust
This command sets the class of service trust mode of an interface. The mode can be set to trust one of the
Dot1p (802.1p), IP Precedence.
Syntax
queue trust {dot1p | ip-dscp | untrusted}
no queue trust
no - This command sets the interface mode to default.
Default Setting
None
Command Mode
Interface Config.
This command sets the class of service trust mode for all interfaces. The mode can be set to trust one of
the Dot1p (802.1p), IP Precedence.
Syntax
queue trust all {dot1p | ip-dscp | untrusted}
no queue trust all
no - This command sets the class of service trust mode to default for all interfaces.
Default Setting
None
Command Mode
Global Config.