Fujitsu PRIMERGY RX1330 M5 User Manual

4.6.2 Installing the top cover 54
4.6.3 Installing the server in the rack 55
4.6.4 Sliding the server into the rack 57
4.7 Connecting the power cord 57
4.7.1 Connecting the power cord (standard PSU) 57
4.7.2 Connecting the power cord (hot-plug PSU) 59
4.8 Switching on the server 60
4.9 Installing the front cover with lock 61
4.10 Handling riser modules 62
4.10.1 Positions of riser modules 62
4.10.2 Removing a riser module 63
4.10.3 Installing a riser module 64
4.11 Handling the air duct 65
4.11.1 Removing the air duct 65
4.11.2 Installing the air duct 66
5 Basic software procedures 69
5.1 Validation 69
5.2 Starting the maintenance task 69
5.2.1 Suspending BitLocker functionality 69
5.2.2 Disabling the boot watchdog 70
5.2.3 Removing backup and optical disk media 72
5.2.4 Verifying and configuring the backup software solution 72
5.2.5 Switching on the ID indicator 72
5.3 Completing the maintenance task 73
5.3.1 Updating or recovering the BIOS and iRMC S6 73
5.3.2 Verifying system information backup or restore 76
5.3.3 Updating expansion card firmware 77
5.3.4 Reconfiguring the backup software solution 78
5.3.5 Resetting the boot retry counter 79
5.3.6 Enabling the boot watchdog 80
5.3.7 Enabling replaced components in the BIOS 81
Content
RX1330 M5 Upgrade and Maintenance Manual

Fujitsu PRIMERGY RX1330 M5 Specifications

General

Processor Sockets	1
Memory	Up to 128 GB
Memory Type	DDR4
Form Factor	1U rack server
Memory Slots	4 DIMM slots
Storage	Up to 4x 3.5" or 8x 2.5" drives
RAID Support	RAID 0, 1, 5, 6, 10, 50, 60
Network	2x 1GbE LAN ports
Power Supply	800W