GE HEALTHCAREDRAFT VOLUSON® P8 / VOLUSON® P6
DIRECTION 5459672-100, R
EVISION 6 DRAFT (JANUARY 17, 2013) PROPRIETARY SERVICE MANUAL
Chapter 3 - Setup Instructions 3-45
3-7-4 Printer Installation manually (cont’d)
13.)Assign a name, decide if printer should be used as default printer and confirm with NEXT
.
NOTE: If the “Printer Sharing” window appears, select ‘Do not share this printer‘ and confirm with NEXT
.
14.)The “Complete the Add Printer Wizard” window appears on the screen.
15.)Complete the manual Printer Installation with the FINISH
button.
NOTE: If the message “The software you are installing for this hardware has not passed Windows ....” appears,
click CONTINUE ANYWAY
.
16.)Close all open windows, close the “System Setup” with SAVE & EXIT
and restart the system
(turn off and on the system).
Figure 3-45 Assign name
Figure 3-46 Complete manual Printer Installation
NOTICE
!! NOTICE:
After boot up of the system, verify the correct settings in the printer “Properties”,
see: Section 3-7-5 "Adjustment of Printer Settings" on page 3-46.
Afterwards assign the Printer to the remote keys P1
, P2, and/or P3/DVR see: Section
3-7-6 "Remote Control Selection" on page 3-53.
To Next Page
Loading...
