GE HEALTHCARERAFT VOLUSON® P8 / VOLUSON® P6
DIRECTION 5459672-100, R
EVISION 6 DRAFT (JANUARY 17, 2013) PROPRIETARY SERVICE MANUAL
5-64 Section 5-15 - LINUX - Voluson Maintenance System
8.) If following message appears, skip the “BT warning” with CONTINUE.
NOTE: Options will be recovered at a later step using “Full Backup” process.
9.) Customize the system as described in Section 5-15-7 on page 5-75.
5-15-5-3 Initialize
This function performs operations which result in complete data loss of all files on C:\ and D:\
partition. The rescue image stored on the Rescue (R:) partition of the hard disk is replaced by the
image from the DVD.
5-15-5-4 NewDisk
NOTE: This function is ONLY available when booting from System DVD.
This function performs operations which result in complete data loss of all files on the entire hard
disk. It re-initializes the hard disk using partition images on the System DVD (setup to factory default).
Figure 5-44 Skip the BT warning with CONTINUE
WARNINGWARNING
All data on D:\ (User) partition (e.g., Patient Archive images, Service Database,
Measurement results, Patient Data and Reports) will be deleted and re-initialized.
NOTICE
If the currently installed software has to be upgraded to a newer version, and the system DVD being
used is SW 13.0.0 or higher, a new software specific”Permanent key” is required.
NOTICE
The [Initialize] function should only be performed if NO System DVD is available!
If you have a System DVD, it is highly recommended to use the [New Disk] function
(see: Section 5-15-5-4 on page 5-64), which is only available when booting from the System DVD.
WARNINGWARNING
COMPLETE DATA LOSS ON THE ENTIRE HARD DISK. Also data on D:\ [User] partition
(e.g., Patient Archive images, Service Database, Measurement results, Patient data and
Reports) will be lost and can not be carried over to the new hard disk.
To Next Page
Loading...
