GE Voluson P6 - Section 8-16 Replacement of the Probe Holder(KIT); 8-16-1 Manpower; 8-16-2 Tools; 8-16-3 Removal Procedure

GE HEALTHCAREDRAFT VOLUSON® P8 / VOLUSON® P6
DIRECTION 5459672-100, R
EVISION 6 DRAFT (JANUARY 17, 2013) PROPRIETARY SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-39
Section 8-16
Replacement of the Probe Holder(KIT)
8-16-1 Manpower
One person, 1 minutes
8-16-2 Tools
None
8-16-3 Removal Procedure
1.) Pull out the PROBE HOLDER to be replaced. Refer to the figure below.
8-16-4 Installation Procedure
1.) Install the new parts in the reverse order of removal.
2.) Perform: FRU8-15: Replacement of the Probe Holder(KIT) - Functional Tests.
Figure 8-46 Removing the PROBE HOLDER