December 2001 10 – 1
10 Error Messages
10.1 DSP Error Messages
NC Software 280 470-xx, 280 472-xx, 280 474-xx ..................... 10 – 3
10.1.1 Non-Axis-Specific DSP Error Messages with Error Code ...... 10 – 3
10.1.2 Axis-Specific DSP Error Messages with Error Code ............. 10 – 5
10.1.3 DSP Error Messages with Text ............................................. 10 – 8
10.2 DSP Error Messages as of NC Software 280 476-01................. 10 – 9
10.2.1 Non-Axis-Specific Error Messages without Control Reset .... 10 – 9
10.2.2 Axis-Specific Error Messages without Control Reset ......... 10 – 10
10.2.3 Non-Axis-Specific Error Messages with Control Reset ....... 10 – 14
10.2.4 Axis-Specific Error Messages with Control Reset ............... 10 – 16
10.3 Comparison of Old and New Error Messages......................... 10 – 22
10.4 TNC Error Messages during Data Transfer.............................. 10 – 29
10.5 Error Codes of the HEIDENHAIN Peripheral Devices.............. 10 – 30
10.6 Error Messages of the File System........................................... 10 – 31
To Next Page
Loading...
