HEIDENHAIN TNC 430 PA/M - Software Type

December 2001 Software 2 – 31
Software type The following software versions are available for the TNC 426 and TNC 430
controls:
Due to restrictions on the export of the TNC, HEIDENHAIN can also supply a
special export version. This export version differs from the standard control
though the installed NC software version. HEIDENHAIN releases a new NC
software version whenever it introduces extensive new functions.
Certain software versions do not run on all hardware versions. Please consult
the following table, which assigns each NC software version to a hardware
version:
NC software version Setup disks Export version
4 EPROMs
280 470-xx
1 disk
280 640-xx
4 EPROMs
280 471-xx
4 EPROMs
280 472-xx
3 disks
280 641-xx
(to 280 641-05 2 disks)
4 EPROMs
280 473-xx
4 EPROMs
280 474-xx
3 disks
286 195-xx
4 EPROMs
280 475-xx
6 EPROMs
280 476-xx
(Delivered software)
4 disks
286 197-xx
(to 286 197-03 3 disks)
6 EPROMs
280 477-xx
NC software version Data record for controls with flash EPROMs
Standard Export
280 476-xx 340 436-xx 340 437-xx
Hardware
version
LE 426 C/P, LE 430 C/P LE 426 M, LE 430 M
324 990-xx to 324 997-xx
(EPROMs)
LE 426 M, LE 430 M
344 958-xx to 344 965-xx
(flash EPROMs)
xxx xxx-1x –– as of 280 476-07
xxx xxx-2x 280 470-xx
280 472-xx
280 474-xx
280 476-xx
–
xxx xxx-3x 280 470-xx
280 472-xx
280 474-xx
280 476-xx
–
xxx xxx-4x 280 470-xx
280 472-xx
280 474-xx
280 476-xx
––
xxx xxx-5x 280 470-xx
280 472-xx
280 474-xx
280 476-xx
––