HEIDENHAIN TNC 430 PA/M - Digitizing with TS

December 2001 List of Machine Parameters 4 – 41
4.3.10 Digitizing with TS (option)
MP Function and input Software
version and
behavior
Page
MP6200 Selection of triggering or measuring touch probe (only with
“digitizing with measuring touch probe” option)
Input: 0: Triggering touch probe (e.g. TS 220)
1: Measuring touch probe
PLC, CN123 6 – 346,
6 – 368
MP6210 Number of oscillations in normal direction per second
Input: 0 to 65.535 [1/s]
PLC, CN123
RUN
6 – 361
MP6220 Traverse distance for lubrication of the touch probe axis at
line end
Input: 0 to 999.999 [mm]
PLC, CN123
RUN
6 – 363
MP6221 Time after which the probe axis must be lubricated
Input: 0 to 65 535 [mm]
PLC, CN123
RUN
6 – 363
MP6230 Feed rate in normal direction
Input: 0 to 1 000 [mm/min]
PLC, CN123
RUN
6 – 361
MP6240 Maximum deflection of the stylus
Input: 0 to 10 000 [mm]
PLC, CN123
RUN
6 – 361
MP6260 Output of M90 in NC blocks with digitized data
Input: 0: No output of M90
1: Output of M90 in every NC block
PLC, CN123
RUN
6 – 361
MP6270 Rounding of decimal places
Input: 0: Output in 0.001-mm steps (1 µm)
0: Output in 0.01-mm steps (10 µm)
2: Output in 0.0001-mm steps (0.1 µm)
PLC, CN123
RUN
6 – 361