December 2001 Display and Operation 6 – 231
6.13.4 Position and Status Display
The status display shows the status of the control.
With a soft key you can activate an additional status display in the graphic
window instead of the graphic.
This information includes:
n Axis positions
n Tools
n Nominal feed rate
n M Functions
Position display
step
To define the position display step for axis and spindle positions:
7
77
7 Enter the desired display step for the axes in MP7290.x and for the spindle
in MP7289.
The position loop resolution is not influenced by this parameter.
MP7290.0-8 Position display step for axes 1 to 9
Input: 0: 0.1 mm or 0.1°
1: 0.05 mm or 0.05°
2: 0.01 mm or 0.01°
3: 0.005 mm or 0.005°
4: 0.001 mm or 0.001°
5: 0.005 mm or 0.005°
6: 0.0001 mm or 0.0001°
MP7289 Position display step for the spindle
Input: 0: 0.1°
1: 0.05°
2: 0.01°
3: 0.005°
4: 0.001°
5: 0.0005°
6: 0.0001°
Position display of
the tool axis
The tool length can be offset in the position display of the tool axis. If it is, the
displayed position value then refers to the tool point:
7
77
7 With MP7285, select whether the tool length should be offset.
The behavior of an incremental block after a TOOL CALL can be determined:
7
77
7 With MP7682 bit 0, select whether the tool length should be offset.
MP7285 Tool length offset in the tool-axis position display
Input: 0: Tool length is not offset
1: Tool length is offset
MP7682 Machine parameter with multiple function
Input: %xxx
Bit 0 – Incremental block after TOOL CALL
0: with length compensation
1: without length compensation
To Next Page
Loading...
