HEIDENHAIN TNC 430 PA/M - Large PLC Window

December 2001 Display and Operation 6 – 255
6.13.8 Large PLC Window
Depending on the display mode, the large PLC window can be shown instead
of the graphic/status window, or even over the entire screen. The PLC
window can be combined with the PLC soft keys.
7
77
7 Select the display mode with the screen management key or with Module
9202.
7
77
7 Define the character size with the special command “charsize = ” (See
"Special commands:” on page 6 – 260). The specified position refers to the
lower left corner of the first character.
The content of the PLC window is defined in a screen mask – an ASCII file
containing format instructions and special commands:
7
77
7 In Module 9210, enter the name of the screen mask in order to activate the
PLC window.
Mode 1 Mode 2
SMALL 17 lines, 39 columns
0 = y16/x8
SMALL 27 lines, 79 columns
0 = y16/x8
MEDIUM 11 lines, 19 columns
0 = y24/x8
MEDIUM 18 lines, 39 columns
0 = y24/x8
LARGE 5 lines, 9 columns
0 = y48/x8
LARGE 9 lines, 19 columns
0 = y48/x8