December 2001 Software Releases 2 – 61
2.6.4 NC Software 280 476-xx and 280 477-xx
NC software
280 476-01 (export
version 280 477-01)
Release: 05/99
Improvements:
n MP340: External interpolation
n MP1097, MP1098: Input range expanded from 1 to 1000 [m/s
3
] to 0.1 to
1000.0 [m/s
3
]
n MP1150 expanded: MP1150.1 Time duration for which monitoring
functions must remain switched off; MP1150.2 Time duration for which
monitoring functions must remain active
n MP2221: Monitoring the reference pulse of the spindle-speed encoder
n MP2360, MP2361: Time constant for deceleration of spindle at
EMERGENCY STOP
n MP2391: Max. braking performance of spindle at EMERGENCY STOP
n MP2393: Performance limit of spindle motor
n MP4030: Assignment physical/logical PL
n MP6585, MP6586: Monitoring the position of the rotary and additional linear
axes during the tool measurement cycles
n MP7245: Disable auxiliary cycles
n MP7266.28: Center offset of sensor in main axis
n MP7266.29: Center offset of sensor in secondary axis
n MP7266.30: Spindle angle during calibration
n MP7411: One block/several blocks of sensor calibration data
n MP7500: Cycle 19 with spatial angle C not equal to 0
n MP7530: Input of a formula for temperature compensation with swivel
heads and tilting tables
n MP73xx: New default values for color settings
n HSC filter: The jerk value in MP1097.x is for curvature changes
n If the fast PLC input defined in MP4130.0 is set, the drive is no longer
switched off automatically.
n New tilting axis combinations for spatial angle
n M4181: NC program selected
n Input value of the rated frequency in the motor table for asynchronous
motors increased from 999.9 Hz to 2000.0 Hz
n Several blocks of touch probe calibration data in the tool table
n In the manual operating modes, the highest axis feed is stored in D388
n Maximum spindle speed with spindle DSP was increased to 30 000 rpm.
n After the drive is switched on, the control waits 1.2 seconds for the “ready”
signal.
n FN17 ID230: Overwrite software limit switches
n FN18 ID990: Number of axes that are programmed in the current datum
table
n Module 9035: Axis-specific handwheel superpositioning (M118)
n Module 9040 and 9041: Reference values with calculated backlash
compensation
To Next Page
Loading...
