HEIDENHAIN TNC 430 PA/M - PLC Compatibility with TNC 415; TNC 425

December 2001 Program Creation 7 – 49
7.5.5 PLC Compatibility with TNC 415 / TNC 425
With machine parameter MP4020 you can establish compatibility with the
TNC 415 by making available the marker range and word range of the
TNC 415.
MP4020 PLC Compatibility with TNC 415 / TNC 425
Format: %xxxxx
Input: Bit 0 = Convert axis words (W1024 and following) to markers
Bit 1 = Convert new markers (4000 and following) to old
markers (2000 and following)
Bit 2 = Convert configuration bits from MP4310 into markers
(M2192 to M2239 and M3200 to M3263)
Bit 3 = Error markers are available
Bit 4 = Remanent markers in the range M1000 to M1999