2 – 40 HEIDENHAIN Technical Manual TNC 426, TNC 430
To delete already existing NC software from the hard disk:
7
77
7 While in the Programming and Editing operating mode, press the MOD key.
7
77
7 Enter the code number 95148.
7
77
7 Press the MOD key.
7
77
7 Press the UPDATE DATA soft key.
7
77
7 Press the DEL/SEL SETUP soft key.
7
77
7 Use the arrow keys to select the desired NC software.
7
77
7 Press the DELETE ALL soft key.
7
77
7 Confirm the confirmation question with the YES soft key.
2.5.5 Data Backup
HEIDENHAIN provides a data backup program called TNCBACK.EXE free of
charge.
HEIDENHAIN recommends that the machine manufacturer use the software
TNCBACK.EXE to save all his machine-specific data to a floppy disk, and that
he supply the disk with the machine. The disk must also contain the program
TNCBACK.EXE.
The customer, too, can save his TNC data before exchanging the control. It is
also advisable that the customer save all of the files and programs created on
the TNC at regular intervals. Data backup is described in detail in the
“Readme” file, which is included on the disk.
To Next Page
Loading...
