HEIDENHAIN TNC 430 PA/M - Digitizing with Measuring Touch Probe

4 – 42 HEIDENHAIN Technical Manual TNC 426, TNC 430
4.3.11 Digitizing with Measuring Touch Probe (option)
MP Function and input Software
version and
behavior
Page
MP6310 Deflection depth of the stylus (measuring touch probe)
Input: 0.1000 to 2.0000 [mm]
PLC, CN123 6 – 368
MP6320 Counting direction of encoder output signals (measuring
touch probe)
Format: %xxx
Input: Bits 0 to 2 represent axes X to Z
0: Positive
1: Negative
CN123 6 – 368
MP6321 Measuring the center offset while calibrating the measuring
touch probe
Input: 0: Calibration with measurement of the
Center offset
1: Calibration without measuring the
Center offset
CN123 6 – 353,
6 – 369
MP6322.0-2 Assignment of the touch probe axes to the machine axes X,
Y and Z
Input: 0: Touch probe axis X
1: Touch probe axis Y
2: Touch probe axis Z
CN123 6 – 369
MP6330 Maximum deflection of the stylus
(measuring touch probe)
Input: 0.1 to 4.000 [mm]
CN123 6 – 369
MP6350 Feed rate for positioning to the MIN point and approaching
the contour (measuring touch probe)
Input: 1 to 3000 [mm/min]
CN123 6 – 369
MP6360 Probing feed rate (measuring touch probe)
Input: 1 to 3000 [mm/min]
CN123 6 – 349,
6 – 369
MP6361 Rapid traverse in probing cycle (measuring touch probe)
Input: 10 to 10 000 [mm/min]
CN123 6 – 350,
6 – 369
MP6362 Feed rate reduction, if the stylus of the measuring touch
probe is deflected to the side
Input: 0: Feed rate reduction not active
1: Feed rate reduction active
PLC, CN123 6 – 369
MP6370 Radial acceleration when digitizing with measuring touch
probe
Input: 0.001 to 3.000 [m/s]
Recommended input value: 0.1
PLC, CN123
RUN
6 – 369
MP6390 Target window for contour line
Input: 0.1000 to 4.0000 [mm]
PLC, CN123 6 – 369