December 2001 Touch Probe 6 – 357
6.15.3 Measurement Log in the Touch Probe Cycles for Probing from the NC program
For every touch probe cycle for probing from the NC program there is a print
mask for all languages. For the HEIDENHAIN touch probe cycles a print mask
is saved for every cycle on the hard disk. This print mask cannot be changed.
However, you can provide an OEM touch probe cycle with a print mask of your
own.
Unlike the print masks for the manual touch probe cycles, for the touch probe
cycles for probing from the NC program you only need one print mask. The
individual text blocks are distinguished through language code words. The text
block that is defined in MP7230.0 is always output.
Otherwise the syntax of the print masks is identical.
Conversational language Language code word
English L_ENGLISH
German L_GERMAN
Czech L_CZECH
French L_FRENCH
Italian L_ITALIAN
Spanish L_SPANISH
Portuguese L_PORTUGUE
Swedish L_SWEDISH
Danish L_DANISH
Finnish L_FINNISH
Dutch L_DUTCH
Polish L_POLISH
Hungarian L_HUNGARIA
Russian L_RUSSIAN
Language neutral texts L_ALL
To Next Page
Loading...
