December 2001 Display and Operation 6 – 225
6.13.2 Color Setting
The colors of the display unit can be defined by machine parameters.
The following color settings cannot be changed:
n HEIDENHAIN logo after machine switch-on (standard color)
n Error message for invalid machine parameters (red)
n Blinking error message (red)
n Plan view in the graphic display (blue)
n Cursor (inverse)
You define the desired color by mixing the basic colors red, green and blue.
Every basic color has 64 difference stages of intensity. The input values for
color setting are byte-oriented. HEIDENHAIN recommends hexadecimal
input.
The colors can also be poorly adjusted (e.g. red error message on red
background). HEIDENHAIN therefore supplies the controls with a standard
color setting, which is suggested by the control during creation of the MP list.
To configure the screen saver:
7
77
7 Enter in MP7392 the time in minutes after which the screen saver should
activate itself. Enter 0 to disable the screen saver.
MP7350 Window frames
MP7351 Error messages
MP7352 ”Machine” operating mode display
MP7352.0 Background
MP7352.1 Text for operating mode
MP7352.2 Dialog
MP7353 ”Programming” operating mode display
MP7353.0 Background
MP7353.1 Text for operating mode
MP7353.2 Dialog
MP7354 ”Machine” program text display
MP7354.0 Background
MP7354.1 General program text
MP7354.2 Active block
MP7354.3 Background of inactive window
MP7355 ”Programming” program text display
MP7355.0 Background
MP7355.1 General program text
MP7355.2 Active block
MP7355.3 Background of inactive window
Color Red Green Blue
Adjustment Rough Fine Rough Fine Rough Fine
HEX ranges 0 to 3 0 to F 0 to 3 0 to F 0 to 3 0 to F
Input for
yellow: $0....
39 3 9 00
To Next Page
Loading...
