HEIDENHAIN TNC 430 PA/M - Axis-Specific Error Messages with Control Reset

10 – 16 HEIDENHAIN Technical Manual TNC 426, TNC 430
10.2.4 Axis-Specific Error Messages with Control Reset
<Axis>: 1 to 9 = axes 1 to 9
S1 = spindle 1
S2 = spindle 2
E00D Error in MP3510
transfer
n MP3510 incorrect.
n Software error MCU.
n Inform your service agency.
• Check MP3510.
• Check software version.
280 476-06
E00E Error in MP2020
transfer
n MP2020 incorrect.
n Software error MCU.
n Inform your service agency.
• Check MP2020.
• Check software version.
280 476-08
Error message Cause Corrective action As of
NC SW
Error message Cause Corrective action As of
NC SW
C110 Unknown motor
type <axis>
n Error in MP file or in
motor table.
n Internal software error.
n Inform your service agency.
• Check MP file and motor
table.
• Check software version.
280 476-01
C140 Pole pair no. too
large <axis>
n Incorrect entry in motor
table.
n Inform your service agency.
• Check the motor table.
280 476-01
C150 Field current error
<axis>
n Incorrect entry in motor
table.
n Inform your service agency.
• Check the motor table.
280 476-01
C160 Grating per. of
motor encoder <axis>
n Measured grating period
does not agree with
entry in the motor table.
n Inform your service agency.
n Check the motor table.
n Check the motor.
280 476-01
C170 Rotor time
constant err. <axis>
n The rotor time constant
calculated from the rotor
table is invalid.
n Inform your service agency.
• Check the motor table.
280 476-01
C180 Rated speed error
<axis>
n Incorrect entry in motor
table.
n Inform your service agency.
• Check the motor table.
280 476-01
C1D0 Current sensor
voltage <axis>
n Incorrect entry in power
module table.
n Inform your service agency.
• Check the power module table.
280 476-01
C1E0 Imax of power
module <axis>
n Incorrect entry in power
module table.
n Inform your service agency.
• Check the power module
table.
280 476-01
C210 Tmax of motor
table <axis>
n Incorrect temperature
entry in motor table.
n Inform your service agency.
• Check the motor table.
280 476-01
C230 Oscilloscope error
<axis>
n Internal software error. n Inform your service agency.
• Check software version.
280 476-01
C240 Irated of power
module <axis>
n Incorrect entry in power
module table.
n Inform your service agency.
• Check the power module table.
280 476-01
C250 Irated of motor
<axis> incorrect
n Incorrect entry in motor
table.
n Inform your service agency.
• Check the motor table.
280 476-01
C260 Imax of motor
<axis> incorrect
n Incorrect entry in motor
table.
n Inform your service agency.
• Check the motor table.
280 476-01
C270 Nmax of motor
<axis> incorrect
n Incorrect entry in motor
table.
n Inform your service agency.
• Check the motor table.
280 476-01