2 – 34 HEIDENHAIN Technical Manual TNC 426, TNC 430
Entries in the log
file
If errors occur during conversion, the TNC will display error messages and log
them in the log file. During the NC software switch, the name and path of a
log file can be entered in the header after Path =; the extension *.A must be
used. If no entry is made in this line, the file TNC:\CVREPORT.A is created.
Each error message contains
n Error message
n Error number
n Error cause
n File concerned
Example:
==================================================
ERROR :REMANENT PLC DATA NOT RESTORED
ERRNO :2
ERROR MESSAGE :Program name not found
FILE :PLCMEM.A
==================================================
Error message Meaning
CANNOT OPEN DIRECTORY Directory cannot be opened
REMANENT PLC DATA NOT
RESTORED
The file PLCMEM.A cannot be accessed
NOT ENOUGH SPACE Not enough free memory on the hard
disk
CONVERSION BIN ASC FAILED A binary file has an incorrect format
(e.g., binary format from an old NC
software)
CONVERSION ASC BIN FAILED An ASCII file on the hard disk is incorrect
To Next Page
Loading...
