December 2001 Input and Output of Machine Parameters 4 – 5
Special case:
Entering a formula
(As of NC software
280 472-01)
Only for MP2020.x (linear distance of one motor revolution); starting with NC
Software 280 476-01 also for MP7530.x (type of dimension for
transformation).
You can enter a formula instead of a fixed value. When entering the formula,
you must pay attention to the case of the letters (whether they are small or
capital). Functions are written small, variables are written in capitals.
Functions:
Variable:
+ Addition sin Sine
– Subtraction cos Cosine
· Multiplication tan Tangent
/ Division asin Arc sine
log Logarithm acos Arc cosine
log10 Logarithm to the base of 10 atan Arc tangent
exp Exponent sqrt Square root
() Expressions in parentheses
are solved
sqr Square
REF Current position of the axis relative to the machine datum
(resolution 0.0001 mm or °)
To Next Page
Loading...
