HEIDENHAIN TNC 430 PA/M - Page 274

4 – 36 HEIDENHAIN Technical Manual TNC 426, TNC 430
MP4060.0-8 Traverse distance for lubrication of axes 1 to 9
Input: 0 to 99 999.999 [mm] or [°]
PLC
RUN
6 – 26
MP4070 Compensation amount per PLC cycle for lagged-tracking
axis error compensation
Input: 0.0001 to 0.005 [mm]
PLC
RUN
6 – 44
MP4110.0-47 Timer preset value T0 to T47
Input: 0 to 65 535 [PLC cycle times]
7 – 17
MP4120.0-31 Counter preset for C0 to C31
Input: 0 to 65 535 [PLC cycles]
7 – 20
MP4130.0 Number of the high-speed PLC input for switching off the
monitoring functions
6 – 157
MP4130.1 Reserved
MP4130.2-5 Numerical designation for fast PLC inputs
Input: 0 to 255 [no. of the PLC input]
TNC 426 M, TNC 430 M:
If you use I32, enter the following
values:
up to 280 474-11: MP4130.0 = 159
as of 280 474-12: MP4130.0 = 32
as of 280 476-01: MP4130.0 = 32
7 – 21
MP4131.0 Activation criterion for fast PLC input for switching off the
monitoring functions
6 – 157
MP4131.1 Reserved
MP4131.2-5 Condition for activating fast PLC inputs
Input: 0: Activation at low level
1: Activation at high level
7 – 21
MP4210.0-47 Setting a number in the PLC (D768 to D956)
Input: -99 999.9999 to +99 999.9999
6 – 205
MP4220.0-4 Setting a number in the PLC (W960 to W968)
Input: 10 to 30 000
7 – 37
MP4230.0-31 Setting a number in the PLC (Module 9032)
Input: -99 999.9999 to +99 999.9999
7 – 37
MP4231.0-31 Setting a number in the PLC (Module 9032)
Input: -99 999.9999 to +99 999.9999
7 – 37
MP4310.0-6 Setting a number in the PLC (W976 to W988, M4300 to
M4411)
Input: 10 to 30 000
7 – 37
MP Function and input Software
version and
behavior
Page