December 2001 List of Machine Parameters 4 – 53
MP7290.0-8 Position display step for axes 1 to 9
Input: 0: 0.1 mm or 0.1°
1: 0.05 mm or 0.05°
2: 0.01 mm or 0.01°
3: 0.005 mm or 0.005°
4: 0.001 mm or 0.001°
5: 0.0005 mm or 0.0005°
6: 0.0001 mm or 0.0001°
PLC, CN123
RUN
6 – 231
MP7291 Display of axes on the screen
Format: SXYZABCUVWxyzabcuvw-
Input: Characters 1 to 9 from the right represent
lines 1 to 9
Character 10 is the spindle “S”, which is always
output in line 9.
PLC
RUN
6 – 5
MP7291.0 Display in traverse range 1
MP7291.1 Display in traverse range 2
MP7291.2 Display in traverse range 3
MP7295 Disabling “datum setting”
Format: %xxxxxxxxx
Input: Bits 0 to 8 correspond to axes 1 to 9
0: Not disabled
1: Disabled
PLC, CN123
RUN
6 – 224
MP7296 “Datum setting” through axis keys
Input: 0: Datum can be set by axis keys and
by soft keys
1: Datum can be set only by soft key
PLC, CN123
RUN
6 – 224
MP7300 Erasing the status display and Q parameters
Input: 0: Status display, Q parameters and
tool data are deleted when the program
is selected.
1: Status display, Q parameters and
tool data are deleted with M02, M30,
END PGM, or when a program is selected.
2: Erase the status display and tool data
when a program is selected.
3: Erase the status display and tool data
when a program is selected or with M02,
M30, or END PGM.
4: Status display and Q parameters are deleted
when a program is selected.
5: Status display and Q parameters are deleted
when a program is selected or with M02,
M30, or END PGM.
6: Erase the status display when a program
is selected, or with M02, M30, or END PGM.
7: Erase the status display when a program
is selected, or with M02, M30, or END PGM.
PLC, CN123
RUN
6 – 241
MP Function and input Software
version and
behavior
Page
To Next Page
Loading...
