HEIDENHAIN TNC 430 PA/M - Page 448

6 – 118 HEIDENHAIN Technical Manual TNC 426, TNC 430
MP1060.0-8 Acceleration for axes 1 to 9
Input: 0.001 to 30.000 [m/s
2
or 1000°/s
2
]
MP1087.0-8 Max. permissible axis-specific jerk for Manual mode
Input: 0.1 to 1000.0 [m/s
3
or 1000°/s
3
]
MP1089.0-8 Max. permissible axis-specific jerk for Pass Over Reference
Point mode
Input: 0.1 to 1000.0 [m/s
3
or 1000°/s
3
]
MP1090 Maximum permissible jerk on the tool path
Input: 0.1 to 1000.0 [m/s
3
or 1000°/s
3
]
MP1090.0 With machining feed rate
MP1090.1 Beginning with feed rate from MP1092
MP1092 Feed rate threshold from which MP1090.1 becomes
effective
Input: 10 to 300 000 [mm/min]
MP1094 HSC filter
Input: 0: HSC filter inactive
0.1 to 166.0: Cutoff frequency for HSC filter
MP1095 Nominal position value filter
Input: 0: Single filter
1: Double filter
MP1095.0 In the Program Run, Full Sequence; Program Run, Single Block;
and Positioning With Manual Data Input operating modes
MP1095.1 In the Manual, Handwheel, Jog Increment and Pass Over
Reference Point operating modes
MP1096 Tolerance for contour transitions
Input: 0: No nominal position value filter
0.001 to 3.000 [mm]: Permissible tolerance at contour
transitions
MP1097.0-8 Max. permissible axis-specific jerk (single/HSC filter)
Input: 0.1 to 1000.0 [m/s
3
or 1000°/s
3
]
MP1098.0-8 Max. permissible axis-specific jerk (double/HSC filter)
Input: 0.1 to 1000.0 [m/s
3
or 1000°/s
3
]
MP1099 Minimum filter order
Input: 0 to 20
MP1099.0 Minimum filter configuration for single filter (MP1095 = 0)
MP1099.1 Minimum filter configuration for double filter (MP1095 = 1)
MP1521 Transient response during acceleration and deceleration
Input: 1 to 255 [ms]
0: Function inactive