December 2001 Commissioning 6 – 505
2. Set the traverse range
Same procedure as for digital axes.
3. Specify the type of control
For control with following error, same procedure as for digital axes.
For control with velocity feedforward control, same procedure as for digital
axes.
4. Perform an offset adjustment
On the TNC: (See "The Control Loop” on page 6 – 109)
5. Activate monitoring functions:
7
77
7 Enter the following temporary input values when you begin: (See "Digital
Axes” on page 6 – 462).
6. Compensate the backlash
Same procedure as for digital axes.
7. Compensate the static (stick-slip) friction
Same procedure as for digital axes.
To Next Page
Loading...
