Hillrom Centrella Smart+ Bed - Wireless Connectivity Specifications

Specifications
140 Centrella® Smart+ Bed Instructions for Use (193587 REV 10)
WIRELESS CONNECTIVITY SPECIFICATIONS
The Wireless Connectivity module supports these security protocols:
Standards
• Wired Equivalent Privacy (WEP)
• Wireless Protected Access (WPA)
• IEEE 802.11i (WPA2)
Encryption
The Wireless Connectivity module supports these encryption protocols:
• Wired Equivalent Privacy (WEP, RC4 Algorithm)
• Temporal Key Integrity Protocol (TKIP, RC4 Algorithm)
• Advanced Encryption Standard (AES, Rijndael Algorithm)
• Encryption Key Provisioning Static (40-bit and 128-bit lengths)
•Pre-Shared (PSK)
• Dynamic 802.1X
• Encryption Options
• Off
•On
•Auto
•PSK
•WPA-TKIP
•WPA2-PSK
• WPA2-AES
•CCKM-TKIP
• CCKM-AES
• WPA-PSK-AES
• WPA-AES
Extensible Authentication Protocol Types (EAP Types)
• EAP-FAST
• PEAP-MSCHAP
• PEAP-MSCHAPv2
• EAP-TLS
• PEAP-TLS
• EAP-TTLS
•LEAP
• PEAP-GTC
NOTE:
The current firmware for the Centrella® Smart+ Beds WiFi interface does not support 802.11r fast
transition authentication key management (AKM)—fast transition-pre-shared key (FT-PSK) or 802.1x-FT.
Cisco/Meraki wireless local area networks (WLANs) on which
Centrella® Smart+ Beds will be connected