Hillrom Centrella Smart+ Bed - ACTIVATE THE TRIAL MODE

Heart and Respiration Rate Monitoring System powered by EarlySense
Centrella® Smart+ Bed with Heart and Respiration Rate Monitoring System powered by EarlySense Instructions for Use 89
(193587 REV 10)
ACTIVATE THE TRIAL MODE
Hill-Rom offers a free 90-day trial of the HR and RR Monitoring System. When the 90-day trial has passed,
the system will turn off or you can contact Hill-Rom for a licensed a activation code to continue to use
the system.
To activate the 90-day trial do these steps:
1. Look at the bed revision. If the bed is revision A, the bed needs
upgraded with the Heart and Respiration Rate (HR/RR) Monitoring
System. Contact Hill-Rom.
If your bed is revision B, the operating system must be software
version 1.29 of higher (see “Settings/Preferences” on page 65). If it
is not, contact Hill-Rom.
NOTE:
The bed must be empty to activate the heart and respiration rate monitoring.
2. Lower the siderails.
3. Disconnect the mattress attachments knobs from the bed frame at
the head end of the bed.
4. Lift the head end of the mattress and remove the protective tab
from the sensor.
5. Reconnect the mattress attachments knob to the bed frame.
6. Press the HR/RR menu control.
7. Contact your local Hill-Rom representative to receive the
activation code. Make sure to specify that the code is for the trial
mode.
8. Press Activate 90-day Trial Mode.
9. Enter the activation code and press Enter.