Bed Frame Features
Centrella® Smart+ Bed Instructions for Use (193587 REV 10) 21
EQUIPMENT SOCKETS
WALLGUARD™ BUMPER SYSTEM
HIP POSITION LOCATOR
LINE-OF-SITE® ANGLE INDICATORS
To Install
Align the footboard pins with the sockets in the frame and then lower the footboard into the sockets.
Push the footboard down until the bottom rests on the frame.
There are four equipment sockets for the
attachment of accessories. They are at each
corner of the bed.
The equipment sockets can be used to
mount IV poles and oxygen tank holders.
NOTES:
• Any equipment in the foot-end equipment sockets will be
included in the scale reading.
• Remove any equipment that was not included during the bed
zero process.
The WallGuard™ Bumper System protects the perimeter of the
bed when it is being moved or transported.
Roller bumpers at the foot end of the bed protect the walls and
doorways when you transport the bed.
The hip position label on the intermediate siderails identifies the correct
position of the patient’s hip while on the bed.
The correct placement of the patient helps to minimize patient migration
to the foot end of the bed when you raise the head section.
• Beds equipped with a mechanical head angle indicator, on the outside
of the right head siderail, mechanically show the approximate angle of
the head section from 0° to 85° with respect to the floor.
The degree where the indicator ball rests is the approximate angle.
•The digital head angle display on the touchscreen gives a more
accurate degree of head elevation.
To Next Page
Loading...
