Hillrom Centrella Smart+ Bed - Power Cord; Cord Holders

Bed Frame Features
18 Centrella® Smart+ Bed Instructions for Use (193587 REV 10)
• Caution—When you use the Chair control, lower the bed, or use the Reverse Trendelenburg
control, make sure that the drainage bags do not touch the floor. Remove them if necessary.
Follow facility protocol if the drainage bags touch the floor.
POWER CORD
CORD HOLDERS
The bed is equipped with a drainage bag holder on each side of the
bed at the foot end. The holders will accommodate a variety of
drainage devices. Follow your facility protocol for placement of
drainage devices.
Make sure drainage bags are placed so they will not touch the floor
during bed articulations, see “Foley Position Limit” on page 72.
NOTE:
The scale reading will be affected by the weight of the drainage bags on the bed. To not include the
drainage bags in the weight, empty or lift the drainage bags off of the holders.
The bed may have two power cords:
•The gray power cord at the head end of the bed supplies power to the bed, and charges the
batteries for the bed frame battery backup and the IntelliDrive® Transport System.
•The white power cord at the head end of the bed supplies power to the optional auxiliary
outlet.
NOTE:
The gray power cord should be plugged into AC power whenever possible to keep the batteries
charged.
Cords can be hung in the openings on the sides of the head- and footboards. Wrap the cords around
the openings so that they do not touch the floor.
NOTE:
Remove the cords from the head- or footboard before you remove the board.