Department Identification Label Placement
Centrella® Smart+ Bed Instructions for Use Manual (193587 REV 10) 143
Operation is subject to these two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, which include interference that may cause unwanted operation of
this device.
The term "IC" before the equipment certification number only signifies that the Industry Canada
technical specifications were met.
To prevent radio interference to the licensed service, this device is intended to be operated indoors and
away from windows to provide maximum shielding. Equipment (or its transmit antenna) that is installed
outdoors is subject to licensing.
Exposure to Radio Frequency Radiation.
The installer of this radio equipment must make sure the antenna is located or pointed such that it does
not emit an RF field in excess of Health Canada limits for the general population; consult Safety Code 6,
obtainable from Health Canada's website http://www.hc-sc.gc.ca/rpb.
Using higher gain antennas and types of antennas not certified for use with this product is not allowed.
The device shall not be co-located with another transmitter.
DEPARTMENT IDENTIFICATION LABEL PLACEMENT
There are two places to place a department identification label, see below:
To Next Page
Loading...
