Hillrom Centrella Smart+ Bed - (Change Zero Items)

Graphical Caregiver Interface (GCI)® Controls
Centrella® Smart+ Bed Instructions for Use (193587 REV 10) 61
+/- (Change Zero Items)
3. Press Re-Zero.
4. A reminder message shows. Follow the on-screen instructions, and
press Continue.
NOTE:
Cancel will return the touchscreen to the previous screen.
5. The touchscreen will show that the bed is zeroing/taring. Do not
touch the bed while the bed zeroes/tares.
NOTES:
• If the “Not Required Position” screen shows, press the Hold to Adjust control on the
touchscreen.
• If the “Difference from Last Zero” caution screen shows, re-check the bed for items that
should be included during the zero.
• The scale will not zero if there is more than a 26 kg weight difference from the last zero.
This is to reduce the possibility of zeroing the scale with a patient in the bed.
6. A single beep will sound and the screen will show that the Re-Zero
is complete.
The +/- control allows you to manually change the weight for items
added to or removed from the bed to correct the patient weight while
the patient is on the bed.
NOTE:
If the patient is not on the bed, use the Re-Zero control.
Before you add or remove items, use the +/- control to keep the patient weight. Then, add an item to or
remove an item from the bed so the item is not included in the patient weight measurement.