Point-Of-Care® Bed Controls
Centrella® Smart+ Bed Instructions for Use (193587 REV 10) 39
Knee Up/Down
Auto Contour™ Feature
PATI EN T PENDANT (HANDHELD REMOTE)
To raise—press and hold the Knee Up control until the bed is at the desired height.
To lower—press and hold the Knee Down control until the bed is at the desired height.
The Auto Contour™ feature does not activate when either the head section or the knee section is
locked out. If only the head section is locked out, you can use the patient controls to adjust the knee
section. If only the knee section is locked out, you can use the patient controls to adjust the head
section.
These controls may or may not be on your configuration of the patient pendant depending on the
model of the patient pendant you have.
Warning—Instruct the patient to store the patient pendant in a patient pendant holder when not in
use; otherwise patient injury could occur.
These controls are on every model of the remote control and do not require the bed to
be connected to the SideCom® Communication System:
•Head Up/Down
•Knee Up/Down
• Foot Up/Down
•Stand Assist
Stay in Bed Indicator—this is on every model of the remote control. The indicator is on
when the Bed Exit is armed.
Soft (-) and Firm (+) controls—these controls are only available when the bed has a
Centrella® max mattress (see “Patient Comfort” on page 106). Continuously press and
release the Soft (-) or Firm (+) control until you reach the desired comfort level. As you
press the control, an indicator turns on to show the firmness level.
The optional controls below require the bed to be connected to a SideCom® Communication System
(see “SideCom® Communication System” on page 41).
• Nurse Call—sends a Nurse Call to the nurses’ station (see “Nurse Call Control”
on page 41).
To Next Page
Loading...
