Hillrom Centrella Smart+ Bed - SafeView+ Alerts Indicators Status; SAFEVIEW+ ALERTS OPTION

Bed Frame Features
26 Centrella® Smart+ Bed Instructions for Use (193587 REV 10)
SAFEVIEW®+ ALERTS OPTION
SafeView®+ Alerts Indicators Status
Beds equipped with SafeView®+ Alerts indicators show the bed status
at the foot end of the bed for these alerts: fewer siderails up than the
set protocol, Bed Exit Alert, Bed in Lowest position, and HR and RR
Alert. With the exception of the HR and RR Alarm, the SafeView®+
Alerts indicators project on to the floor to provide an additional visual
status of these bed conditions.
The projections may be turned on or off through the Settings menu
control on the touchscreen. See “SafeView®+ Alerts Floor Projections
Option—ON/OFF” on page 67.
NOTE:
New Patient Zero will reset the SafeView®+ Alerts option to the facility’s default settings.
Siderail Protocol Status—On
A green siderail indicator shows when the minimum number of siderails are up
as set in the siderail protocol. The indicator will flash amber if fewer siderails
are up than the set siderail protocol.
NOTES:
• If more siderails are up than the set siderail protocol, a green siderail indicator will still show.
• The siderail protocol can be changed for special patient needs through the Settings menu
control on the touchscreen. See “Siderail Protocol” on page 68.
Bed Exit Alert Status—On
A green Bed Exit Alert indicator shows when a patient is in bed and the Bed Exit
Alert is armed. The indicator will flash amber when a Bed Exit Alert occurs.
The Bed Exit Alert will show solid amber when the Bed Exit Alert is silenced.
Bed Exit Alert Status—Off
A blue crossed out Bed Exit Alert indicator shows when the Bed Exit Alert is off.
Bed in Lowest Position Status—On
A green Bed in Lowest Position indicator shows when the bed is in the lowest
bed position. The indicator will flash amber when the bed is not in the lowest
bed position.
HR and RR Monitoring powered by EarlySense Status—On
A green HR/RR indicator shows when the HR and RR monitoring is On, a patient
is in the bed, and the HR/RR measurements are within the HR/RR thresholds.
The indicator will flash amber when an HR/RR measurement is outside the set
thresholds. If the indicator is white, the HR and RR monitoring is On, but either
the patient is not in the bed, or the system could not detect the patient’s HR or
RR.
The HR/RR Alarm will show solid amber when the HR/RR Alarm is silenced.