Graphical Caregiver Interface (GCI)® Controls
76 Centrella® Smart+ Bed Instructions for Use (193587 REV 10)
Set Up the Bed Association Using the Room/Patient Icon
At the Home screen, press the Room or Patient icon, then do as
applicable:
• If the Bed Location screen shows, a room association is in the
bed’s memory, go to “Confirm the Room to Bed Association” on
page 77.
• If a location (such as Facility or Building) screen shows, a room is
not in the bed’s memory, go to “Associate a Room to the Bed”
on page 76.
Associate a Room to the Bed
1. Select the correct options for the location, such as Building, Floor,
and Room number.
NOTES:
• For the Available rooms screen, if you press the Associated
rooms control, a list of rooms that are associated to beds will
show.
• For all location selection screens, if you press Cancel, the Home
screen will show.
• The location selection screens may have up to five levels of
hierarchy: facility, building, unit, floor, and rooms. The Other
Location control allows you to scroll up and down through the
levels.
• You may see a “Retrieving data” screen as the bed gets the information from the Hillrom™
Digital Health Gateway.
2. After you select the room number, the bed will retrieve the room
data, then associate the room to the bed. You will be asked to verify
the patient identity (if applicable), you have these options:
• Continue—press this control if you want to verify the patient.
See “Verify the Patient Identity” on page 77.
• Cancel—press this control if you do not want to verify the patient. The Home screen will show.
• Change Room—press this control to associate a different room to the bed. The bed will retrieve
room data, and then the Available Rooms screen will show. See Step 1.
To Next Page
Loading...
