Hillrom Centrella Smart+ Bed - Page 64

Graphical Caregiver Interface (GCI)® Controls
50 Centrella® Smart+ Bed Instructions for Use (193587 REV 10)
To Silence a Bed Exit Alert
1. Press the Silence control on the siderail caregiver controls until the indicator next to the control is
on, or press Silence on the touchscreen.
NOTES:
• For the Position and Exiting modes, center the patient in the bed before you resume the Bed
Exit monitoring.
• For the Out of bed mode, the bed will resume the Bed Exit monitoring when the patient gets in
the bed.
2. Press the applicable option:
• 1 Minute or 5 Minutes—if a 30 second silence period is not
long enough, select 1 or 5 Minutes to add time.
While silenced, if the patient exits the bed, the alert will not sound.
After the patient has returned to the bed, the Bed Exit Alert will
attempt to re-arm in the previously set mode. The Bed Exit Alert will
attempt to re-arm when the patient sits on the bed. The system will
not be able to re-arm in the Exiting or Position Modes unless the
patient is in the center of the bed.
• Resume—immediately turns the Bed Exit Alert on.
• Bed Exit Off—turns the Bed Exit Alert off. The touchscreen will
prompt you to confirm that you want to turn off and stop
monitoring the patient for Bed Exit.
NOTES:
• If you finish the task before the silence timer has expired, press Resume to reactivate the Bed
Exit Alert. Do not leave the patient unattended until Resume is pressed and the Bed Exit
system is reactivated. The Bed Exit Alert will not be active and will not convey its status until it
has been reactivated or the timer has ran out.
• A low volume repeating triple beep will occur every 10 seconds to remind you that the Bed
Exit is silenced and should be resumed before you leave the room.
• For the Position and Exiting modes, center the patient in the bed before you resume the Bed
Exit monitoring.
• For the Out of Bed mode, the bed will resume the Bed Exit monitoring when the patient sits in
the bed.