Hioki 3159 - FAIL Mode

91
_____________________________________________________________________________________________
6.6 FAIL Mode
______________________________________________________________________________________________
0
:
Not set (Initial setting)
1
:
Set
6.6 FAIL Mode
Enable this function to restrict hold release to the STOP keyonthemain
unit.
1.
Press SHIFT + STOP keys while in READY state to display the Optional
function setting screen.
2.
Use the / keys to move the flashing cursor to the position shown in the
figure.
3. Use the
/ keys to set a value at the flashing cursor location.
4. To complete the optional settings, press
SHIFT + STOP keys. The unit
reverts to the READY state.