Hioki 3159 - 5.3 SETTING State

72
_____________________________________________________________________________________________
5.3 "SETTING " State
______________________________________________________________________________________________
Auto Test Mode
Make insulation resistance mode
test settings
Make withstand voltage mode
W I
/
I W
key
NOTE
When using withstand voltage or insulation resistance mode, if the test time is set to
OFF and Auto test mode is selected, the test mode for which test time is switched
OFF
is displayed, and "
OFF
" flashes. In this case, the test cannot be started because
the unit is not in the READY state (
READY
is not lit). Return to withstand voltage
or insulation resistance mode
,
and set the test time to ON.
Flashing
5.3 "SETTING" State
In Auto test mode, test settings cannot be changed. To change test settings,
the withstand voltage and insulation resistance modes must be in the
SETTING state. (See Section 3.3 and 4.3)
After you have made the various test settings, select Auto test mode.