Hioki 3159 - Connection Method

126
_____________________________________________________________________________________________
9.2 Connection Method
______________________________________________________________________________________________
3159
GND
RxD
TxD
GND
PC
TxD
RxD
RTS
CTS CTS
RTS
3159
GND
RxD
TxD
GND
PC
TxD
RxD
RTS RTS
CTS CTS
9.2 Connection Method
Use a cross cable for connection to the PC. If the hardware flow control
signal (RTS and CTS) is not used, the 3159 will not perform hardware flow
control.
RTS is connected with CTS in the 3159.
Connecting cable
Connector on cable side: D-Sub 9 Pin female
Connection: Reverse connection
Connection to Computer
1. Connect the 3159 to the computer using a cross cable.
2. Perform the RS-232C settings on the computer side. For details on how to
make the settings, refer to the instruction manual for the computer.