Hioki 3159 - Page 115

103
_____________________________________________________________________________________________
7.1 Saving Preset Values
______________________________________________________________________________________________
1
2
3
4
5
6
7
8
9
1
0
11
1
2
1
3
1
4
A
Comparative voltage value: OFF
Upper limit value: 100 mA
Lower limit value: 15 mA
Test time: 8.0 s
Output voltage range: 2.5 kV
3. Use the
/
keys to select File No.3.
This example shows File No. 1. Press the key twice to display File
No.3.
4. Use the
key to confirm the comparative voltage value and outputvoltage
range, and the key to confirm the upper- or lower-limit value.
In this example, File No. 3 contains the following settings.
5.
To save the data, press SHIFT + keys. The unit reverts to the READY
state. Once saved, the value set in the READY state is retained in File
No.3.
Note that File No.3, shown in Step (4) above, is deleted.
To abort the save procedure, press the STOP key at Step (4). The unit
halts the save procedure and reverts to the READY state.