Hioki 3159 - Page 7

i
_____________________________________________________________________________________________
______________________________________________________________________________________________
NOTE
Before using the product, make sure that the insulation on the leads is undamaged
and that no bare conductors are improperly exposed. Using the product in such
conditions could cause an electric shock, so contact your dealer or Hioki
re
p
resentative for re
p
air.
Introduction
Inspection
Thank you for purchasing the HIOKI 3159 INSULATION/WITHSTANDING
HiTESTER. To obtain maximum performance from the product, please read
this manual first, and keep it handy for future reference.
When you receive the product, inspect it carefully to ensure that no damage
occurred during shipping. In particular, check the connectors. If damage is
evident, or if it fails to operate according to the specifications, contact your
dealer or Hioki representative.
Accessories
Verify that the following standard accessories are complete.
Instruction Manual 1
Spare fuse (built into the power inlet) 1
Grounded three-core power cord 1
9615 H.V. TEST LEAD (High voltage and return side ) 2
Shipment of the unit
Use the original packing materials when reshipping the product, if possible.
Warranty
HIOKI cannot be responsible for losses caused either directly or indirectly by
the use of the 3159 with other equipment, or if ownership is transferred to a
third party.