Hioki 7075 - Page 132

122
────────────────────────────────────────────────────
8.4.2 Specific Commands
────────────────────────────────────────────────────
Disk
:FILE
Commands
Parameters
Explanation
Transmission Response Parameter explanation
:FILE:SAVE "<file>"
Saves the setting file.
:FILE:LOAD "<file>"
Loads the setting file.
:FILE:DELete "<file>"/"<dir>"
"<dir>"= directory name
Deletes the file or
directroy.
:FILE:FORMat
Formats a disk.
:FILE:CHDir "<dir>"
Changes the current
directory.
:FILE:DIR? "<dir>"
Queries the current
directory name.
:FILE:FILE? <no.>
<no.>=Number of files
(NR1)
Queries the number of
files in the current
directory.
:FILE:LIST? "<file1>","<file2>",...
Queries the list of file
name in the current
directory.
:FILE:INFor? "<file>"
"<file>",FILE/DIRECTORY
Queries whether a file or
directory
Data input
:MEMory
Commands
Parameters
Explanation
Transmission Response Parameter explanation
:MEMory:WAVE:
RECeive?
"<name>" "<name>"<range>,
<freq>,<amp>,
<offset>,<no.>,
#0<binary>[NL]
"<name>"=waveform
name
<range>=R10V/R1V/
R0_1V
<freq>=clock frequency
(NRf)
<amp>=amplitude (NRf)
Unit:V
<offset>=offset (NRf)
<no.>= data count
NR1[words]
#0<binary>[NL]=
waveform data (binary
format)
Outputs the waveform
data.
:MEMory:WAVE:
ADATa
"<name>"<range>,<freq>,<amp>,
<offset>,<no.><wave>
<wave>=waveform data
Enters the waveform
data.
:MEMory:WAVE:
SEND
"<name>"<range>,<freq>,<amp>,
<offset>,<no.>,#0<binary>[NL]
Enters the waveform
data.
:MEMory:SWEep:
RECeive?
<ch> <ch>,#0<binary>
[NL]
<binary>=Sweep data
(binary format)
Outputs the sweep data.
:MEMory:SWEep:
SEND
<ch>,#0<binary>[NL]
<binary>=Sweep data
(binary format)
Enters the sweep data.