Hioki 7075 - Page 150

APPENDIX 2
────────────────────────────────────────────────────
Appendix 2 Error Message List
────────────────────────────────────────────────────
Error No. Message Description
Output Setting Errors
201 Cannot change RANGE while
running.
Press STOP, then change range.
202 Cannot change WAVE while
running.
Press STOP, then change waveform.
203 Cannot set frequency of another
channel.
Cancel simultaneous setting of frequency, or
cancel simultaneous setting.
Sweep Related Errors
301 Value out of range.
The time setting value is out of range.
302 Value out of range.
The number of loop time is out of range.
303 Value out of range.
The frequency is out of range.
304 Value out of range.
The duty is out of range.
305 Value out of range.
The amplitude value is out of range.
306 Value out of range.
The offset value is out of range.
307 No data.
Create data and try the operation again.
308 Not a data file.
The file does not contain (sweep) data.
309 Cannot read data.
(Sweep) data cannot be read correctly.
310 Cannot convert.
(Sweep) data cannot be converted.
311 Cannot convert while running.
Data cannot be converted during RUN
operation.
312 Cannot change while running.
The data cannot be executed during RUN
operation.
313 No ARB wave.
There is no waveform (arbitrary waveform
specified in the file).
Output Status File Errors
351 Value out of range.
The time setting value is out of range.
352 Value out of range.
The number of loop time is out of range.
353 Value out of range.
The frequency is out of range.
354 Value out of range.
The duty is out of range.
355 Value out of range.
The amplitude value is out of range.
356 Value out of range.
The offset value is out of range.
357 No data.
Create data and try the operation again.
358 Not a data file.
The file does not contain (output settings) data.
359 Cannot read data.
(output settings) data cannot be read correctly.
360 Cannot load while running.
The data cannot be loaded during RUN
operation.
Appendix 2 Error Message List