81
────────────────────────────────────────────────────
8.3.1 Standard Command
────────────────────────────────────────────────────
Syntax
*ESE <NR1>
<NR1> = 0 to 255
Example
Transmission
*ESE 36
Bits 5 and 2 of SESER are set to 1.
Syntax
*ESE?
Response
syntax
(Headers: ON) (Headers: OFF)
*ESE <NR1> <NR1>
Example
Transmission
Response
*ESE?
36
Syntax
*ESR?
Response
syntax
(Headers: ON) (Headers: OFF)
*ESR <NR1> <NR1>
Example
Transmission
Response
*ESR?
32
Indicates command error occurs.
(bit5 corresponds to CME.)
Function
Loads the effective format of the
Standard Event Status Register (SESR)
into the Standard Event Status Enable
Register (SESER).
Decimals are rounded off.
128 64 32 16 8 4 2 1
bit 7 bit 6 bit 5 bit 4 bit 3 bit 2 bit 1 bit 0
PON URQ CME EXE DDE QYE RQC OPC
Note
When the power is turned on, the data is
reinitialized to 0.
Error
(Command error)
When <NR1> was not in NRf format.
Function
The contents of SESER as set by the
*ESE command are returned as a NR1
value (0 to 255).
Note
If any error occurs, no response message
to this query is produced.
Error
With this query, if any error occurs, no
response message is produced.
Function
The contents of SESR are returned as
NR1 value (0 to 255).
128 64 32 16 8 4 2 1
bit 7 bit 6 bit 5 bit 4 bit 3 bit 2 bit 1 bit 0
PON URQ CME EXE DDE QYE RQC OPC
Error
With this query, if any error occurs, no
response message is produced.
*ESE (GP-IB only)
Sets the standard event status enable register.
*ESE? (GP-IB only)
Queries the standard event status enable register (SESER).
*ESR?
Queries out and clears the contents of the standard event status register (SESR).
To Next Page
Loading...