Hitachi 902 - Page 394

16 - 27
(g) Where the barcode reader is not provided, a test selection response from the host to
the real-time inquiry should be made within two cycles (= 36 seconds). If this period
of time is exceeded, the analyzer does not accept the test selection request.
(h) Unless the barcode reader is provided, the same position No. as on the analyzer
side is set and transferred.
(i) Specification of test selection made from the host is ignored if the analyzer is set in
the original Abs. mode. In test selection, priority is given to the analyzer side.
(j) Sample No., position No. and ID No. sent from the host may become invalid
depending on the mode of analyzer.
O: Host's specification followed ×: Invalid
Sample
With or
Without ID
Sample
No.
Position
No.
ID No. Remarks
Routine
sample
With (ID mode) × × O
Without (sample
No. mode)
O O O
Stat
sample
With (ID mode) × O O As disk position No., send
the same No. as the
inquiry No. from analyzer.
Without (sample
No. mode)
× × × Inquiry is not made in this
mode.