16 - 29
Table 16-13 Detailed Information about "SPE: Specification of test slection (from host to anal yzer)"
2 Characters Sample Information, Recommended Character in Parens
Operation Instrument Sample 5 Characters 1 Character 3 Characters 13 Characters 15 Characters
Mode Mode Name Function
Character
Sample No. Unassigned Position No. ID No. Unassigned Remarks
Simple
analysis
mode
ID mode Routine
sample
New sample (Press the registration key on
screen by the number of samples to be
analyzed.)
A (Space)
Ignored
(Space)
Ignored
1 to 35 Desired ID No.
(blank
unallowable)
(Space)
Ignored
Unallowable [Caution 1]
The position No. specified from
the host must be within the
Stat
sample
Sample registered for stat TS through
screen
D (Space)
Ignored
(Space)
Ignored
2 to 35
[Caution 1]
Sample and ID
No. registered
on screen (blank
unallowable)
range specified on the stat
sample position setting screen.
If the position No. is outside the
range or 0 is specified, sample
information error occurs.
Sample No.
mode
Routine
sample
New sample (Press the registration key on
screen by the number of samples to be
analyzed.)
N 1 to 400 (Space)
Ignored
1 to 35 Desired 13
characters
(blank
unallowable)
(Space)
Ignored
Stat
sample
Sending is unallowable.
Routine
analysis
mode
ID mode Routine
sample
New sample (Specify the analysis start
No. and the number of samples to be
analyzed through screen.)
A (Space)
Ignored
(Space)
Ignored
1 to 35 Desired ID No.
(blank
unallowable)
(Space)
Ignored
Unallowable
Stat
sample
Sample registered for stat TS through
screen
D (Space)
Ignored
(Space)
Ignored
2 to 35
[Caution 1]
Sample and ID
No. registered
on screen (blank
unallowable)
(Space)
Ignored
Unallowable
Sample No.
mode
Routine
sample
1. New sample
2. Registered sample
N 1 to 400 (Space)
Ignored
1 to 35 Desired 13
characters
(blank
unallowable)
(Space)
Ignored
Stat
sample
Sending is unallowable.
Supplementary Explanation
1. Basically, text should be transferred with TS and comment presence/absence information added to the same sample information (excluding ID No.) as for inquiry from the analyzer.
Basic Condition for TS Specification
[RUN] (highlighted) is specified for host
communication on start condition screen,
[CANCEL] is specified for the transfer of
analytical data alone on the
[communication parameter screen and
[CANCEL] is specified for original Abs.
Stop
Specification
from HOST
To Next Page
Loading...
