13. Remove the front end module of the blocked controller and the cables
connected to LAN.
14. Loosen the blue screw that secures the blocked controller and open the
lever.
Note: The POWER, READY, WARNING, and ALARM LEDs might go off. If
the LED on the front goes off, check whether any component other
than the controller is normal in the Maintenance Utility window and
continue the procedure. The green READY LED on the front of
CBSS/CBSL goes on after you restore the controller at the end of
the replacement procedure.
15. Wait at least 20 seconds, and then push the controller all the way in and
close the lever.
16. Tighten the blue screw and secure the controller.
17. Connect the cables you removed to the front end module and LAN.
18. Connect new SAS cables to the CBSS/CBSL back end module and the
ENC of the drive tray connected to the CBSS/CBSL.
Replacing a SAS cable 239
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
