10. Confirm that the red STATUS LED on the back end module whose SAS
cable you want to replace is on.
11. Unroute the SAS cable connected to the CBLM or CBLH.
Note: When replacing the SAS adapter for DW-F800-SCQ1HA, you
do not have to release the routing of the SAS cable.
12. Remove the SAS cable from the back end module on the CBLM or CBLH.
13. Remove the SAS cable from the ENC on the drive tray connected to the
CBLM or CBLH.
14. For SAS cable DW-F800-SCQ1HA:
a. Loosen the blue two screws that secure the back end module.
b. Hold the blue screw, and then gently pull out the back end module
slightly.
c. Wait at least 20 seconds, and then re-insert the back end module
before the "shield finger."
d. Push the back end module slightly.
e. Tighten the two blue screws to secure the back end module.
Replacing a SAS cable 243
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
